Installation - Sharp IV-C35M User Manual

Leave enough space around the controller (IV-C35M)
In order to connect camera cables, the remote key pad cable, monitor cable and D-sub connector to
the controller, the following space (min.) is required.
9mm
X0
Y0 Y1
COMPACTFLASH
VIDEO CAMERA1
Monitor cable*

[2] Installation

To install the IV-C35M controller, secure the bottom of the housing on the mounting surface with the two
main housing brackets (supplied with the controller.)
Main housing bracket
Mounting procedure
1. Install the main housing angle bracket at the bottom of the IV-C35M housing, and secure using 4
screws (M3 x 6: Accessory).
Bottom view
Screw installation position
(4 places)
148mm
130mm
INPUT
X1 X2 X3 X4 X5 X6 X7
COM 24V
IV-C35M
Y2 Y3 Y4 Y5 Y6 Y7 READY COM 0V
OUTPUT
POWER
USB
CAMERA2 REMOTE
RS232C/RS422
Camera cable
Connection and Installation Methods
· Do not bend the camera cables repeat-
edly.
9mm
· Make sure the installation location allows
enough space for the input/output wires
going to the I/O terminal block and the
power terminal block on the controller.
* Monitor cable and D-sub connector are
accessories of the IV-C35M controller.
D-sub connector*
Card cover
- When using a memory card, install a card
cover (accessory) on the IV-C35M housing.
See page 6-17.
Mounting surface
5-9
Main housing bracket
(2 pcs.)
5