Running An Internal Test - HP Surestore Tape Library Model 2/28 User Manual

Library Operation

Running an Internal Test

Running an Internal Test
CAUTION
Some diagnostic tests, such as Exchange Demo, may place tape cartridges in
unexpected locations, which can cause problems with the software
application being used.
NOTE
Some diagnostic tests can only be run through the SCSI interface. Refer to
Digital Linear Tape Drive and Library SCSI-2 Command Reference (HP
part number 5960-7674) for information about these tests.
To run self-diagnostic tests:
1. Verify that the drive status displays (if not, press
2. Press
3. Enter the three-part numerical password (see "Entering the
4. INFO* displays. Press
5. Press
6. NUM LOOPS 1 displays, where the 1 is flashing. Press
NOTE
Press
while the current test loop completes.
The following table describes the internal tests available from the control
panel. Tests are listed alphabetically according to function.
4-36
until ADMIN* appears in the display window, then press
NEXT
.
ENTER
Administration Menu Password" on page 3-7).
.
ENTER
until the name of the test to run displays, then press
NEXT
number of test loops you wish to run displays, then press
at any time to abort a test. TEST CANCEL - WAIT displays
CANCEL
or until TEST* displays, then press
NEXT PREV
until it does).
CANCEL
.
ENTER
until the
NEXT
.
ENTER