Table of Contents
Advertisement
5. For each bus, set the SCSI interface mode switch as follows.
Table 2-4
SCSI Interface Mode Switch Settings
Term Pwr
Termination
CAUTION
Do not use a physical terminator. If a physical terminator is attached and
termination is set to ON, the bus will be overterminated, which could cause
the device to function incorrectly.
Setting
Purpose
Sends termination
power to the bus
Terminates the SCSI
bus; functions the same
as a physical
terminator
Library Installation
Step 4: Connect the Library to the Host
Set to
ON
ON if one port on the bus is
open
OFF if both ports on the bus
are connected to a cable
2-7
Advertisement
Table of Contents
