Library Operation
Removing Cartridges from the Library
5. Remove the cartridge from the mailslot. To eject additional cartridges,
6. Press
If a Tape Cartridge Will Not Eject
Table 4-5
Removing Tape Cartridge Error Messages
Message
EMPTY displays,
then EJECT*
displays
EJECT ERROR
MAILSLOT FULL
SOURCE NOW
EMPTY
RESERVED
TRANSPORT
FULL
4-20
repeat step 4 until all cartridges to eject are removed.
twice to return to the drive status ("ready" state).
CANCEL
The library storage slots are empty.
The mailslot is jammed. If a cartridge in the mailslot cannot be removed, or
if the problem cannot be fixed, call a service representative.
A cartridge must be removed from the mailslot before another cartridge
can be ejected.
The cartridge was moved from that slot before it could be ejected.
SECURE MS has been set. This option prevents cartridges from being
loaded into or removed from the library. See "Setting a Configuration
Option" on page 4-27.
The cartridge transport mechanism already contains a tape cartridge.
Consult your software package documentation. A service call may be
needed.
Cause