Table of Contents
Advertisement
Library Operation
Loading Cartridges Into the Library
4. LOADING displays. After the cartridge is loaded into the selected storage
5. Press
If a Tape Cartridge Will Not Load
The following conditions may prevent a tape cartridge from loading.
Table 4-4
Loading Tape Cartridge Error Messages
Message
LOAD ERROR
MAILSLOT EMPTY
DEST NOW FULL
RESERVED
TRANSPORT FULL
MAILSLOT
SENSOR
FAILED
4-16
slot, LOAD* displays. (If an error message displays, see the following
section.) Load additional cartridges by repeating steps 2 and 3 until all
cartridges are loaded.
twice to return to the drive status ("ready" state).
CANCEL
The cartridge may have been inserted incorrectly or a mechanical error
may have occurred. A service call may be needed.
A cartridge needs to be inserted into the mailslot.
A cartridge was moved into that slot before the current tape could be
inserted.
SECURE MS has been set. This option prevents cartridges from being
loaded into or removed from the library. See "Setting a Configuration
Option" on page .
The cartridge transport mechanism already contains a tape cartridge.
Consult your software package documentation. A service call may be
needed.
The cartridge may be inserted incorrectly into the mailslot. If the error
cannot be corrected by removing and reinserting the cartridge, the
mailslot sensors may be bad and a service call is needed.
The cartridge could not be pulled into the mailslot. If the error cannot be
corrected by removing and reinserting the cartridge, a service call is
needed.
Cause
Advertisement
Table of Contents
