Viewing The Current Scsi Address Settings; Setting The Scsi Addresses - HP Surestore Tape Library Model 2/28 User Manual

Library Operation
Specifying SCSI Addresses

Viewing the Current SCSI Address Settings

1 2 3 4 ADMIN*
To view the current SCSI address settings:
1. Verify that the drive status displays (if not, press
2. Press until ADMIN* displays, then press
NEXT
3. Enter the three-part numerical password (see "Entering the
Administration Menu Password" on page 4-7).
4. Press until SCSI IDs* displays, then press
NEXT
5. SET IDs* displays. Press
.
ENTER
6. BUS0 LIB ID# or BUS# DRV * ID * displays. (BUS0 LIB ID # stands
for the current SCSI ID of the robotics controller.
BUS# DRV # ID # is the current SCSI ID setting for the displayed drive
number and its associated BUS#.)
Press or
NEXT PREV
7. Press until the next operation to perform displays, or until the
CANCEL
drive status (library "ready" state) displays.

Setting the SCSI Addresses

1 2 3 4 ADMIN*
A SCSI address is required for the robotics controller and each tape drive.
For more information, see Table 4-2, "Default SCSI Address Settings" on page
4-9, and the section "Viewing the Current SCSI Address Settings" on page
4-10.
To change the current SCSI address settings:
1. Verify that the drive status displays (if not, press
2. Press until ADMIN* displays, then press
NEXT
3. Enter the three-part numerical password (see "Entering the
Administration Menu Password" on page 4-7).
4. Press until SCSI IDs* displays, then press
NEXT
4-10
PSWD 000-000-000
until VIEW IDs* displays, then press
NEXT
to scroll through the current address settings.
PSWD 000-000-000
SCSI IDs* VIEW IDs*
until it does).
CANCEL
.
ENTER
.
ENTER
SCSI IDs* SET IDs*
until it does).
CANCEL
.
ENTER
.
ENTER