Table of Contents
Advertisement
Library Operation
Cleaning the Tape Drives
Drive Cleaning Issues
Table 4-7 lists circumstances that can cause a drive cleaning message,
appear when a tape cartridge may be at fault. Note that:
• The tape drives do not require scheduled cleaning maintenance.
• After 20 cleaning cycles, the cleaning cartridge must be replaced.
Table 4-7
Drive Cleaning Issues
Problem
A new data tape
cartridge is used and a
drive cleaning
message displays.
An older,
frequently-used data
tape cartridge is
loaded and a drive
cleaning message
displays.
An older, frequently
used tape causes a
cleaning message to
display for the second
time.
Cleaning errors do not
go away after three
cleaning cycles.
4-26
Excessive use of the cleaning cartridge can cause unnecessary wear on
the drive head.
Cause
Debris from the tape
manufacturing process
has been deposited on
the drive head.
Dust from frequent tape
loads and unloads has
most likely built up on
the tape cartridge and
was deposited on the
drive head.
The tape is probably
damaged. (Damaged
cartridges can cause
unnecessary use of the
cleaning cartridge.)
Debris has been
deposited on the head of
the drive in such a way
that cleaning will not
remove it.
Solution
Clean the drive using the tape library
cleaning procedure in "Cleaning the Tape
Drives" on page 4-23.
If the message displays again within a
short amount of time, return the cartridge
for a warranty replacement.
Clean the outside of the tape cartridge
using a damp cloth.
Clean the tape drive using the tape drive
cleaning procedure in "Cleaning the Tape
Drives" on page 4-23.
Clear the error message by unloading and
then reloading the problem tape cartridge.
Back up data from the damaged cartridge
to another tape cartridge and discard the
damaged one.
Contact an HP qualified service
representative. The drive may need to be
replaced.
C
, to
Advertisement
Table of Contents
