HP Surestore Tape Library Model 2/28 User Manual page 82

Library Operation
Running an Internal Test
Table 4-10 Tests Available from the Control Panel (Continued)
Test Name
FIND PLUNGE
HOME
FIND VERT HOME
FIND XLATE
HOME
INIT MECHANICS
EMPTY DRIVES
EMPTY PICKER
FILL PICKER
CLEAR SOFT LOG
CLEAR HARD LOG
PLUNGE FULL SPD
PLUNGE 1/2 SPD
4-38
Runs mechanism recalibration, determines the reference points in the picker
travel path, and tests the picker. This test assumes that the mechanics and servo
system are functional. No tape cartridges required.
Recalibrates the vertical position and verifies that the vertical path is clear. No
tape cartridges required.
Calibrates the translate position. No tape cartridges required.
Runs the FIND PLUNGE HOME, FIND VERTICAL HOME, FIND XLATE
HOME, and INIT ELEM STATUS tests. Each test is run one time per test
loop.
Do not run test if library contains customer data cartridges.
Moves cartridges out of the drive mechanisms and returns them to their
home storage slot locations if the locations are known, otherwise the
cartridges are placed into the first available empty storage slot.
Do not run test if library contains customer data cartridges.
Moves a tape cartridge from the cartridge transport mechanism to its
home storage slot location if that location is known, otherwise the
cartridge is placed into the first available empty storage slot.
Do not run test if library contains customer data cartridges.
Moves a tape cartridge into the cartridge transport mechanism from the
first storage slot containing a cartridge.
Sets the soft error log to zero.
Sets the hard error log to zero.
Allows the cartridge transport mechanics to run at full speed. This setting should
always be used under normal library operation.
Allows the cartridge transport mechanics to run at half speed.
Description