Setting The Robotics Controller Bus Type - HP Surestore Tape Library Model 2/28 User Manual

Setting the Robotics Controller Bus Type

1 2 3 4 ADMIN*
BUS*
Two bus settings are available:
• Differential
• Single-ended
To set the bus type:
1. Verify that the drive status displays (if not, press
2. Press until ADMIN* displays, then press
NEXT
3. Enter the three-part numerical password (see "Entering the
Administration Menu Password" on page 4-7).
4. Press until SCSI IDs* displays, then press
NEXT
5. Press until SET LIB BUS* displays, then press
NEXT
DIFFERENTIAL displays.
6. Press to toggle between DIFFERENTIAL or SINGLE ENDED. Press
NEXT
to set the bus type.
ENTER
DIFFERENTIAL BUS or SINGLE ENDED BUS displays briefly, then
SCSI IDs* displays.
7. Press until the next operation to perform displays, or until the
CANCEL
drive status (library "ready" state) displays.
PSWD 000-000-000
ENTER
Library Operation
Specifying SCSI Addresses
SCSI IDs* SET LIB
until it does).
CANCEL
.
.
ENTER
.
ENTER
4-13