Setting Up A Controller Pair Using The Ocp; Entering The Wwn - HP 6400/8400 User Manual

Operating system type
Available LUN numbers

Setting up a controller pair using the OCP

NOTE: This procedure should be performed by an HP authorized service representative.
Two pieces of data must be entered during initial setup using the controller OCP:
World Wide Name (WWN) — Required to complete setup. This procedure should be
performed by an HP authorized service representative.
Storage system password — Optional. A password provides security allowing only specific
instances of HP P6000 Command View to access the storage system.
The OCP on either controller can be used to input the WWN and password data. For more
information about the OCP, see
Table 9 (page 31)
password data.
Table 9 Push button functions
Button
ESC
ENTER

Entering the WWN

Fibre Channel protocol requires that each controller pair have a unique WWN. This 16-character
alphanumeric name identifies the controller pair on the storage system. Two WWN labels attached
to the rack identify the storage system WWN and checksum. See
"Operator Control Panel" (page
lists the push-button functions when entering the WWN, WWN checksum, and
Selects a character by scrolling up through the character list one character at a time.
Moves forward one character. If you accept an incorrect character, you can move through all 16
characters, one character at a time, until you display the incorrect character. You can then change
the character.
Selects a character by scrolling down through the character list one character at a time.
Moves backward one character.
Returns to the default display.
Accepts all the characters entered.
14).
Function
Figure 24 (page
Procedures for getting started
32).
31