Table of Contents
Advertisement
NORMAL: Acquire waveform when trigger occurred.
SINGLE: Acquire waveform when trigger occurred then stop
Source: You can use the trigger source options to select the signal that the oscilloscope
uses as a trigger. The source can be any signal connected to a channel BNC, or to the
EXT. BNC.
CH1: Select CH1 as trigger signal
CH2: Select CH2 as trigger signal
CH3: Select CH3 as trigger signal
CH4: Select CH4 as trigger signal
EXT: Select EXT as trigger signal
PW Condition: Set the PW Condition to the following condition.
+More
: +Pulse width more than set pulse condition.
+Less
: +Pulse width less than set pulse condition.
+Equal
: +Pulse width equal to set pulse condition.
-More
: -Pulse width more than set pulse condition.
-Less
: -Pulse width less than set pulse condition.
-Equal
: -Pulse width equal to set pulse condition.
Pulse Width: The Pulse Width adjust range is 10ns~10s. When the condition is met ,it
will trigger and acquire the waveform.
Advertisement
Table of Contents
