Set The Measurement Parameters - Tenma 72-7910 Manual

Create (F1)
Horizontal
(F2 and @)
Vertical
(F3 and @)
Return (F4)
You will need to press F1 to confirm creating the pixel template after setting the
horizontal and vertical length of the pixels.
8. Set the Measurement Parameters
The oscilloscope supports up to 28 automatic waveform measurement parameters. You
can view 5 measurement parameters at the same time the most on F1‐F5 function menu.
To view measurement parameters, please press MEASURE on the control panel.
Figure 2‐24 Function Key of Auto Measurement Parameters
For each measurement parameter located at F1‐F5 on the function measurement, you
can press F1‐F5 for the settings (Measurement Sub Menu)
Table 2‐24 Measurement Sub Menu
Function
Menu
Back (F1)
/ According to adjustment, build
horizontal and vertical Pass/Fail
tolerance range
1‐200 Press [F2] to select horizontal length and
Pixel use the multi‐purpose knob to set the
pixel length for the horizontal length
1‐100 Press [F3] to select vertical length and
Pixel use the multi‐purpose knob to set the
pixel length for the vertical length
/ Return to pass detection menu
Settings Description
Return to measurement parameter
50
Model 72‐7610/72‐10510 User Manual