Tenma 72-10175 User Manual page 26

The user can change Time/Div, format in the panel.
5. The Vertical Panel
The user can turn on/off the CH1/CH2/CH3/CH4. Also the user can change the CH1/
CH2/CH3/CH4 volt/div, coupling and probe attenuation.
6. The Trigger Panel
In this panel, the user can change the trigger mode, sweep, source and slope.
7. Displays the system time.
8. Marker shows Edge trigger level.
9. Displays the main time base setting.
10. Displays the CH4 information
Readouts show the coupling of the channels.
Readouts show the vertical scale factors of the channels.
A "B" icon indicates that the channel is bandwidth limited.
Displays the CH3 information
11.
Readouts show the coupling of the channels.
Readouts show the vertical scale factors of the channels.
A "B" icon indicates that the channel is bandwidth limited.
12. Displays the CH2 information
Readouts show the coupling of the channels.
Readouts show the vertical scale factors of the channels.
A "B" icon indicates that the channel is bandwidth limited.
13. Displays the CH1 information
Readouts show the coupling of the channels.
Readouts show the vertical scale factors of the channels.
A "B" icon indicates that the channel is bandwidth limited.
14. Displays the software status.
15. The markers show the reference points of the displayed waveforms. If there is
no marker, the channel is not displayed.
16. The same above.
17. The same above.
18. The same above.
TENMA 72-10175
DIGITAL OSCILLOSCOPE