Param.
Prefix
0
UPS Identification, Serial number, Start-up Date, software version
1
Input line-line and line-neutral V/I values, V/I percent of rated value, and frequency
2
Output line-line and line-neutral V/I values, V/I percent of rated value, and frequency
3
Bypass line-line and line-neutral V/I values, V/I percent of rated value, and frequency
4
DC Bus Voltage, DC Under Voltage Level, Startup Voltage Level
5
Battery Voltage/Current, shutdown voltage, battery test enable
6
Control and Configuration - UPS time/date/status, faults, warnings, password management
7
UPS Operation time, Number of Faults, Backup, Operations.
8
Display and Ext Comm. - Disp. S/W version, buzzer status, display calibration values.
RemotEye I/P address, data and network status.
Pressing an active button will cause a list of parameters to be displayed (See previous page). Pressing a
listed parameter will activate a display appropriate to the parameter selections available If the parameter
cannot be edited at the current security level, the display will not change. If the parameter can be edited
4200FA Installation and Operation Manual
Figure 9-14 Setup Tab
Table 9.10 Setup Parameter Categories
Parameter Category
77