Turning The Scanner On And Off; Turning The Scanner Off - Fujitsu fi-6670 Operator's Manual

Chapter 1 Scanner Overview

1.4 Turning the Scanner ON and OFF

This section describes how to turn the scanner ON and OFF.
Turning the Scanner ON
The following shows the procedure for turning the scanner
ON.
For a SCSI cable connection, be sure to turn on your computer
AFTER turning on the scanner, and making sure number "1"
indicates on the Function Number Display.
1
Press the "I" side of the Main Power Switch.
2
Press the [Power] button on the Operator Panel.
Flatbed type
[Power] Button
ADF type
Function
Scan / Stop
Power
Check
Send to
⇒
The scanner is turned on, and the Power LED lights in green.
Check
Function
Send to
Scan / Stop
Power
Note that, while the scanner is being initialized, the Function Number
Display changes as follows: "8"
scanner is in the Ready Status.
Use the Main Power Switch to turn the power ON if the
Operator Panel power switch has been disabled.
For details, refer to "8.7 Settings Related to Power ON/
OFF Control" (on page

Turning the Scanner OFF

The following shows the procedure for turning the scanner
OFF.
1
Press the [Power] button on the Operator Panel for more
than 2 seconds.
⇒
The power is turned off and the Power LED goes off.
• If you will not use the scanner for a long time, press
the "O" side of the Main Power Switch to turn the
power OFF. Then, unplug the scanner from the power
outlet.
• Use the Main Power Switch to turn the power OFF if
the Operator Panel power switch has been disabled.
For details, refer to
OFF Control" (on page
"P" "1", where "1" means the
167).
"8.7 Settings Related to Power ON/
167).
TOP
Contents
Index
Introduction
Scanner
Overview
Loading
Documents
Scan
Parameters
Various
Documents
Daily Care
Consumables
Trouble-
shooting
Operational
Settings
Appendix
Glossary
31