Loading Documents On The Adf; Overview; Documents; Parameters - Fujitsu fi-6670 Operator's Manual

Chapter 2 Loading Documents

2.1 Loading Documents on the ADF

This section describes how to load documents on the ADF.
• Refer to
"2.2 ADF-Loaded Documents" (on page 42)
information about the required document sizes and paper
quality for ensuring correct operation when scanning
documents from the ADF.
• Refer to
"2.3 Changing the ADF Position (Flatbed Type
Only)" (on page 48) for how to change the ADF position
(Flatbed type only).
1
Align the edge of your document.
1 Confirm that all the document sheets have the same width.
2 Check the number of sheets in the document stack.
The following is a guideline for the limits on loadable sheets:
•
A4/Letter-size paper or smaller that makes a document stack
of 20 mm (0.79 in.) or less (200 sheets with paper weight of
2
80 g/m (20 lb))
•
A4/Letter-size paper or larger that makes a document stack
of 10 mm (0.39 in.) or less (100 sheets with paper weight of
2
80 g/m (20 lb))
For details, refer to "Maximum Document Loading Capacity" (on
page 44).
2
To avoid sticky edges, fan the document as follows:
1 Hold both ends of the document, and bend the document stack
into an arch.
2 Firmly holding the document with both hands, bend it back so that
the bent section rises up in the middle of the document as follows.
for
3 Repeat Steps 1 to 2 twice or three times.
4 Turn the document stack by 90 degree, and then fan it in the differ-
ent orientation again.
5 Align the edge of the document.
For details of how to fan documents, refer to the Error
Recovery Guide.
You can find the Error Recovery Guide in the Setup DVD-
ROM. For how to install the Error Recovery Guide, refer to
"Chapter 4 Installing the Scanner Software" in the Getting
Started.
3
Load the document on the ADF Paper Chute.
Load it face down on the ADF Paper Chute.
TOP
Contents
Index
Introduction
Scanner

Overview

Loading

Documents

Scan

Parameters

Various

Documents

Daily Care

Consumables

Trouble-

shooting

Operational
Settings
Appendix
Glossary
39