Loading; Overview; Documents; Parameters - Fujitsu fi-6670 Operator's Manual

Chapter 2 Loading Documents
4
Adjust the Side Guides to the width of the document.
Slide the Side Guides so that they will touch both sides of the
document tightly.
Any gap between the Side Guides and the document edges may
make the scanned images skewed.
• Remove paper clips or staples from the document. If a
multifeed or mis-picking occurs, reduce the number of
the document in the ADF Paper Chute.
• When loading a small document, be careful not to
touch the hood for the Chute Roller during scanning.
Doing so may let the hood open, which may catch your
finger.
5
Pull out the Stacker Extension to the length of the
document, and then raise the Stopper to stop the
document.
Adjust the height of the Stacker according to the paper
type of the document.
Select the lower position for ordinary use.
When scanning a thin or curled document, select the
upper position.
Lower position (Normal paper)
Upper position (Thin paper)
The number of document sheets loadable on the ADF
decreases when the upper position is selected (about 100
sheets if the paper weight is 80 g/m
6
Start up the application supported by the scanner to scan
the document.
For how to scan documents using ScandAll PRO, refer to "ScandAll
PRO V2.0 User's Guide".
TOP
Contents
Index
Introduction
Scanner

Overview

Loading

Documents

Scan

Parameters

Various

Documents

Daily Care

Consumables

Trouble-

shooting

2
(20 lb)).
Operational
Settings
Appendix
Glossary
41