Scanning Documents Of Different Widths; Trouble; Shooting; Operational - Fujitsu fi-6670 Operator's Manual

Chapter 4 Various Documents
4
Select [Flat Bed] under [Scan Type].
5
Specify a desired paper size from [Paper Size], etc.
6
Click the [OK] button.
⇒
The changes made are applied.
7
From ScandAll PRO, perform a scan.
For how to perform a scan, refer to "ScandAll PRO V2.0 User's
Guide".
AUTION
Never look into the light source directly during
scanning.
• Do not move the document during scanning.
• For a document of up to A3 or Double Letter size, be
sure to close the Document Cover before scanning.

Scanning Documents of Different Widths

When you scan documents of different widths, scan them,
following the procedure below.
When you scan documents of different widths at one time from
the ADF, some documents that are small in paper size may be
skewed or may not be fed into the scanner. It is recommended
that only documents of the same width be scanned at one time.
1
To prevent images from being skewed, select [Automatic
Page Size Detection] from the [Automatic Size and Skew
Detection] drop-down list.
For how to configure the settings, refer to
Skewed Document Images" (on page
2
Center all the document sheets as shown in the figure
below.
Inside the opening of the ADF is a Pick Roller, which picks
and feeds documents into the ADF. Therefore, off-center
documents, if out of contact with the Pick Roller, cannot
be fed into the scanner.
"Automatically Correcting
77).
TOP
Contents
Index
Introduction
Scanner
Overview
Loading
Documents
Scan
Parameters
Various
Documents
Daily Care
Consumables

Trouble-

shooting

Operational

Settings

Appendix
Glossary
64