Chapter 8 Operational Settings
Configuring the Data Transfer Width
[SCSI Bus Width]
Specify the data transfer width when the connection is via
VRS option.
1
Start up the Software Operation Panel.
Refer to
"8.1 Starting Up the Software Operation Panel" (on page
134).
2
From the tree listing on the left, select [Device Setting 2]
[SCSI Bus Width].
3
Select [16 bit(Wide)] or [8 bit].
Select [8 bit] if using any SCSI card or SCSI cable that
does not support Ultra Wide SCSI.
Scan Setting for Documents with Tabs or Non-
Rectangular Documents
[Scan Setting for Documents with Tab (Automatic
Paper Size Detection)]
When configuring settings to scan a non-rectangular
document with a tab (index) or tab (index) sticker at the its
bottom, you can scan and include such a tab or tab sticker in
the scanned image when [Automatic Paper Size Detection] is
selected.
1
Start up the Software Operation Panel.
Refer to
"8.1 Starting Up the Software Operation Panel" (on page
134).
2
From the tree listing on the left, select [Device Setting 2]
[Scan Setting for Documents with Tab (Automatic Paper
Size Detection)].
TOP
Contents
Index
Introduction
Scanner
Overview
Loading
Documents
Scan
Parameters
Various
Documents
Daily Care
Consumables
Trouble-
shooting
Operational
Settings
Appendix
Glossary
154