Image Scanning Application - Fujitsu fi-6670 Operator's Manual

Chapter 1 Scanner Overview

1.7 Image Scanning Application

This section explains about the bundled "ScandAll PRO"
image scanning application, which is used as an example to
explain the procedures in this manual.
ScandAll PRO supports both TWAIN and ISIS drivers. By
defining scan settings as profiles, you can customize the
settings according to your preference.
When ScandAll PRO is installed, you can also install
"ScandAll PRO ScanSnap mode Add-in". This is an add-in
application which provides a different set of driver settings as
an alternative to using ScandAll PRO. TWAIN driver is
required to use this application. Using the ScandAll PRO
ScanSnap mode Add-in enables easy scanning with a single
button.
You cannot use ScandAll PRO ScanSnap mode Add-in in the
following cases:
• When the scanner is connected to fi-5000N
• When the scanner is connected with a SCSI cable
"Chapter 4 Various Documents" (on page 61)
scan different types of documents by using examples of the
TWAIN driver started via ScandAll PRO.
For more details about ScandAll PRO, refer to "ScandAll PRO
V2.0 User's Guide".
For details about ScandAll PRO ScanSnap mode Add-in, refer
to the ScandAll PRO ScanSnap mode Add-in V1.0 User's
Guide.
explains how to
TOP
Contents
Index
Introduction
Scanner
Overview
Loading
Documents
Scan
Parameters
Various
Documents
Daily Care
Consumables
Trouble-
shooting
Operational
Settings
Appendix
Glossary
36