[Access Restrictions] Page; [Access Restrictions] (*1) - JVC VN-H557U Instructions Manual

[Access Restrictions] Page

This page is for setting client restrictions.
This page can be used during access using
"admin".
Click [Advanced Settings] in the side menu, and
0
click [Access Restrictions].
Press the [OK] button to enable the new
0
settings.
If the [OK] button is pressed upon entering an
0
invalid value, a warning message will appear
and the entry will be denied. Press the [Cancel]
button to restore the invalid entry to the value
before the change was made. If you press the
[Cancel] button, other changed items will also be
restored to the values before the change was
made.
Memo :
This feature is applicable for restricting the
0
acquisition of H.264/JPEG or audio
transmission data. It does not impose
restrictions on access via a web browser or use
of API.
Note :
The Access Restriction feature determines
0
whether to impose restrictions during TCP
connection by the client. In the case when
access restriction is set after TCP connection by
a client has been established, TCP connection
will not be disconnected.
Settings
* Setting values with R are default values.
[Advanced Settings] Page - [Access Restrictions] Page
60
Client Address
Restrictions may be imposed on clients accessing
the camera using the IP address.
Access Restriction
Deny:
0
Denies acquisition of H.264/JPEG or audio
transmission data from the IP address specified
in [IP Address]. Restrictions are not imposed on
access to the setting page.
Allow:
0
Accepts acquisition of H.264/JPEG or audio
transmission data from the IP address specified
in [IP Address]. Restrictions are not imposed on
access to the setting page.
[Set values: RDeny, Allow]
IP Address
You can register up to 10 IP addresses for
prohibited or permitted clients.
Memo :
To specify a specific IP address range, enter a
0
combination of the IP address and subnet mask
in the [IP Address] item.
Define the subnet mask using a length between
0
8 to 30 bits.
For example, to specify the range from
192.168.0.0 to 192.168.0.255, 192.168.0.0/24
([IP address]/[bit length of subnet mask]) is
used.
Note :
Note that when "Allow" is selected and all IP
0
address fields are left blank, acquisition of H.
264/JPEG or audio transmission data from all IP
addresses will be denied.
Restrictions are not imposed on access to the
setting page.
Additionally, the camera will also deny access
when instructions for transmission to the
specified IP address are sent via API.