Peripheral Drive Errors; Miscellaneous Hardware - Intergraph StudioZ RenderRAX III System Setup

Peripheral Drive Errors

CD-ROM drive LED does not light when system power is on:
Reason
CD-ROM drive power cable or data cable
not attached.
Floppy disk drive LED does not light when system power is on:
Reason
The drive's power cable or data cable is not
attached.

Miscellaneous Hardware

"Battery voltage low" message displays:
Reason
Lithium battery voltage on the system board
is low.
System loses BIOS configuration information:
Reason
Lithium battery voltage on the system board
is low. The system also displays a "battery
voltage low" message during the system boot.
One or more RAID controllers is not recognized:
Reason
Message displays, Host adapter at
baseport dc90h is not responding.
RAID controller firmware has been
corrupted.
Solution
Open the base unit and ensure power cable
and data cable are properly attached. See the
System Reference.
Solution
Open the base unit and ensure power cable
and data cable are properly attached.
Solution
Replace the battery on the system board.
Solution
Replace the lithium battery on the system
board.
Solution
Remove the RAID controller and reinstall it
into the same slot, ensuring it is completely
connected into the slot.
Call the Customer Response Center.
67