Intergraph StudioZ RenderRAX III System Setup page 64

54
Hard Disk Power Down Mode
This option specifies the power conserving state that the hard disk drive enters after the
specified period of hard drive inactivity has expired. The settings are Disabled, Standby, and
Suspend. The Optimal default setting is Suspend.
Hard Disk Timeout (Minute)
This option specifies the length of a period of hard disk drive inactivity. When this length of
time expires, the computer enters power-conserving state specified in the Hard Disk Power
Down Mode option. The settings are Disabled and 1 - 15 minutes. The Optimal default
setting is Disabled.
Power Saving Type
The settings are POS, Sleep, Stop Clock, and Deep Sleep. The Optimal default setting is
Sleep.
Standby / Suspend Timer Unit
The settings are 4 milliseconds, 4 seconds, 32 seconds, and 4 minutes. The Optimal default
setting is 4 minutes.
Standby Time Out
This option specifies the length of a period of system inactivity while in Full On state. When
this length of time expires, the computer enters Standby power state. The settings are Disabled
and 4 - 508 minutes. The Optimal default setting is Disabled.
Suspend Time Out
This option specifies the length of a period of system inactivity while in Standby state. When
this length of time expires, the computer enters Suspend power state. The settings are Disabled
and 4 - 508 minutes. The Optimal default setting is Disabled.
Slow Clock Ratio
This option specifies the speed at which the system clock runs in the Standby Mode power
saving state. The settings are expressed as a percentage of the normal CPU clock speed. The
settings are 0 - 12.5, 12.5 - 25, 25 - 37.5, 37.5 - 50, 50 - 62.5, 62.5 - 75, and 75 - 87.5. The
Optimal default setting is 50 - 62.5.