Creating An Emergency Repair Disk - Intergraph StudioZ RenderRAX III System Setup

See SCSI Configuration Utility Help and the Symbios SCSI adapter documentation for
instructions on using the SCSI Configuration Utility.
NOTE Change the synchronous data transfer rate or the data width parameters for an individual
device only. Do not change the parameters for the SCSI host adapter itself. Changes to the
SCSI host adapter affect all devices on its bus.
To change the synchronous data transfer rate:
1. Run the SCSI Configuration Utility as described previously.
2. From the main menu, select the SCSI host adapter that you want to configure and press
ENTER
3. From the Utilities menu, select Device Selections and press
4. From the Device Selections menu, select the SCSI device that you want to configure and
press
ENTER
NOTE Only eight SCSI devices are listed at a time. Select Device Selections 8-15 to list the next
eight SCSI devices.
NOTE If the device that you want to configure is not listed, exit the menu, repeat step 5 and select
the other host adapter. Then continue with step 6.
5. Select Sync Rate (Megabytes/sec) and press
6. Select the appropriate rate (Off, 10, 20, or 40) and press
and then press
7. From the Device Selections menu, select Exit This Menu and press
8. From the Utilities menu, select Exit This Menu and press
displays.
9. Select Save Changes and press
10. Remove the diskette from the system's floppy disk drive, and then press any key to restart
the system.

Creating an Emergency Repair Disk

You should create an Emergency Repair Disk after you finish configuring the system. The
files on the Emergency Repair Disk can restore a damaged registry to its original contents
(that is, at the time Windows NT was installed), along with the standard Windows NT drivers.
Use the
RDISK
Software") to create an Emergency Repair Disk. You can also use these utilities to update the
Emergency Repair Disk any time you change the system's configuration. You should also
make and keep a backup copy of the Emergency Repair Disk.
. One single-channel SYM8751 SCSI host adapter is listed.
.
.
ENTER
. utility or InterSite Welcome (as described in Chapter 2, "Setting Up the
EXE
.
ENTER
.
ENTER
.
ENTER
, select Exit This Menu,
ENTER
.
ENTER
. The Save/Cancel menu
ENTER
31