Intergraph StudioZ RenderRAX III System Setup page 75

System hard disk drive is not recognized:
Reason
Hard disk drive power cable not attached.
Hard disk drive SCSI cable not attached.
SCSI termination is enabled on the hard disk
drive you installed.
Some viruses cause the system to not
recognize hard disk drives.
CD-ROM drive is not recognized:
Reason
CD-ROM drive power cable not attached.
CD-ROM EIDE drive cable not attached.
Total amount of memory does not display:
Reason
Faulty DIMM(s).
DIMM(s) not properly seated into socket(s).
I/O Card parity error message displays:
Reason
Faulty option board is installed in ISA slot.
Solution
Open the base unit and ensure power cable is
properly attached. See the System
Reference.
Open the base unit. Ensure the SCSI cable is
properly attached at both ends. See the
System Reference.
Disable the SCSI termination. See the
documentation with the hard disk drive.
Run a virus scan program that checks the
Master Boot Record. Clear any viruses
detected by the program.
Solution
Open the base unit and ensure power cable is
properly attached. See the System
Reference.
Open the base unit and ensure cable is
properly attached. See the System
Reference.
Solution
Identify faulty DIMM(s) by swapping
DIMM(s) until the faulty one is found. See
the System Reference.
Ensure DIMM(s) are properly installed. See
the System Reference.
Solution
Remove ISA board, then restart the system.
See the System Reference.
65