Pci/Plug And Play Setup - Intergraph StudioZ RenderRAX III System Setup

55
Display Activity
When set to Monitor, this option enables event monitoring on the video display. If set to
Monitor and the computer is in a power saving state, the BIOS watches for display activity.
The computer enters the Full On state if any activity occurs. The BIOS reloads the Standby
and Suspend timeout timers if display activity occurs. The settings are Monitor and Ignore.
The Optimal default setting is Ignore.
Device 6 (Serial port 1), Device 7 (Serial port 2), Device 8 (Parallel port), Device
5 (Floppy disk), Device 0 (Primary master IDE), Device 1 (Primary slave IDE),
Device 2 (Secondary master IDE), Device 3 (Secondary slave IDE)
When set to Monitor, these options enable event monitoring of the specified hardware device.
If set to Monitor and the computer is in a power saving state, the BIOS watches for activity on
the specified device. The computer enters the Full On state if any activity occurs. The BIOS
reloads the Standby and Suspend timeout timers if activity occurs on the specified IRQ line.
The settings for each option are Monitor and Ignore. The Optimal default setting is Ignore.
LAN Wake-Up
The Optimal default setting is Disabled.
PC98 Power LED
The Optimal default setting is Disabled.
FAN OFF at Suspend
The Optimal default setting is Enabled.
RTC Wake-Up
The Optimal default setting is Disabled.
Hour, Minute The Optimal default setting is N/A.

PCI/Plug and Play Setup

Plug and Play Aware O/S
Set this option to Yes to inform the BIOS that the operating system can handle plug and Play
(PnP) devices. The settings are No and Yes. The Optimal default setting is No.