Intergraph StudioZ RenderRAX III System Setup page 57

47
3rd Boot Device
This option sets the type of device for the second boot drives that the BIOS attempts to boot
from after POST completes. The settings are Disabled, 1st IDE-HDD, 2nd IDE-HDD, 3rd
IDE-HDD, 4th IDE-HDD, Floppy, ARMD-FDD, ARMD-HDD, and Atapi CD-ROM. The
Optimal default setting is Atapi CD-ROM.
Try Other Boot Devices
The Optimal default setting is Yes.
Initial Display Mode
The Optimal default setting is Silent; the other setting is BIOS.
Floppy Access Control
The Optimal default setting is Read-Write.
Hard Disk Access Control
The Optimal default setting is Read-Write.
S.M.A.R.T. For Hard Disks
Set this option to Enabled to permit the BIOS to use the SMART (System Management and
Reporting Technologies) protocol for reporting server system information over a network. The
settings are Enabled and Disabled. The Optimal default setting is Enabled.
BootUp Num Lock
Set this option to Off to turn the Num Lock key off when the computer is booted so you can
use the arrow keys on both the numeric keypad and the keyboard. The settings are On and Off.
The default setting is On.
PS/2 Mouse Support
Set this option to Enabled to enable the BIOS support for a PS/2-type mouse. Pins 2-3 of the
PS/2 Mouse Selector jumper on the motherboard must be jumpered to enable PS/2 mouse
support. The Optimal default setting is Enabled.
Primary Display
This option configures the type of monitor attached to the computer. The settings are Absent,
VGA/EGA, CGA40x25, CGA80x25, and Mono. The Optimal default setting is VGA/EGA.