Observing Operating Precautions - Intergraph StudioZ RenderRAX III System Setup

To log on to the operating system:
1. If the logon dialog does not display, press
2. Type a username and password into the appropriate boxes.
3. If appropriate, type a domain name.
4. Select OK or press
To log off, restart, shut down, or power down the system:
1. Go to Start/Shut Down.
2. To log off the operating system, click Close all programs and log in as a different user.
To restart the system, click Restart the computer.
To shut down the system, click Shut down the computer.
3. Click Yes to activate the selected shutdown option.
4. You can turn off power to the system when prompted after the shutdown procedure
completes.
After shutting down and turning off power to the system, wait at least 30 seconds before
restarting the system. This allows the power supply to stabilize and the disk drives to stop
spinning.
If external RAID disk array cabinets are connected to the system, always power on or off the
system as follows:
u
Turn power on to the InterRAID cabinets first, listen for the audible beep, and then turn
on power to the system base unit.
u
Turn off power to the system base unit first, and then turn power off to the InterRAID
cabinets. If you turn power off to the InterRAID cabinets first, the RAID controller will
read the drives in those cabinets as dead the next time you turn power on to the system. If
this happens, refer to the Mylex documentation for drive recovery procedures.

Observing Operating Precautions

Observe the following precautions when operating the system:
u
When restarting the system, use the operating system controls instead of turning the
power switch off and on. Use the power switch only when instructed, or as the last
alternative for restarting the system.
u
Never turn off power to the base unit when the disk access LED is lit.
u
After turning off power to the base unit, wait at least 30 seconds before turning the power
on again
CTRL
.
ENTER
+ + to display it.
ALT DELETE
35