Peripheral/Adapter Problems - Gateway 7400 System Manual

Peripheral/adapter problems

The system does not recognize a SCSI device.
Probable cause
The device needs to be
added as new hardware
The SCSI ID may be invalid
The SCSI chain is not
properly terminated
The device cables are not
installed correctly
The system does not recognize an adapter card.
Probable cause
The interrupt or I/O address
is set incorrectly
The card was not configured
through the software
The card was not installed
correctly
Solution
In the Control Panel window (Start | Settings |
Control Panel), double-click Add New
Hardware. Follow the on-screen instructions
for adding the device.
Assign an available SCSI ID to the device.
Make sure the last device on the SCSI chain
is terminated.
Open the system and check all cables
between the controller and the device. Install
the cables correctly if necessary.
Solution
Check the address configuration of the adapter
card and make sure that it does not conflict
with another card in the system.
Configure the card with the appropriate
software.
Make sure that the jumpers are configured
correctly, then reseat the card.
Peripheral/adapter problems
113