Gateway 7400 System Manual page 42

8
Remove the mounting rails from the hard drive.
9
Place the old drive in an antistatic bag or container, then place the new
hard drive on a static-free surface with the top up and the connectors
facing you.
10
Install the two drive mounting rails on the new hard drive, making sure
the front rail extensions are to the front of the device. The rails are
labeled.
11
Set the drive jumpers to the appropriate settings (refer to your drive
documentation for jumper settings.)
12
Align the rails with the open bay at the bottom of the drive stack, then
slide the drive into the stack until the locking tabs snap into place (make
sure that the data and power connectors on the drive face the inside of
the server).
13
Connect the power and data cables to the drive. (See the drive
documentation for proper cable orientation.)
14
Replace the bezel. (See "Replacing the bezel" on page 28.)
15
Close the case. (See "Closing the case" on page 27.)
16
Reconnect the power cord, the modem cord, and all other external
peripheral devices, then turn on the system.
34
Replacing and Adding System Components