Closing The Case; Replacing The Side Panel - Gateway 7400 System Manual

Closing the case

Close the chassis as soon as you finish installing or removing components
so that dust and dirt do not collect inside the server.

Replacing the side panel

Closing the side panel covers the internal components. You must close the
side panel and replace the front bezel before you can operate the server. If
you do not, a system intrusion event is logged by the system management
hardware. Be careful not to pinch any cables with the panel as you replace it.
To replace the side panel:
1
Hold the side panel 3/4-inches forward of the chassis. Engage the
retaining tabs on the bottom edge of the panel with the slots at the
bottom edge of the chassis.
2
Swing the top of the panel toward the chassis, engaging the retaining
tabs on the top edge of the side panel with the slots on the chassis.
3
Slide the panel toward the back of the chassis 3/4-inch, securing it in
place, then tighten the thumbscrews.
Closing the case
27