Gateway 7400 System Manual page 70

Troubleshooting the battery installation
If you have problems after installing the new battery, try each of the items
listed below:
Turn off the server and make sure that all exterior cables are attached
and secured to the correct connectors.
Make sure that all power switches are on. If the server is plugged into a
power strip, surge protector, or UPS, make sure it is turned on also.
Enter the BIOS Setup utility and compare the settings on the screen with
your notes or the system hardware manuals. Correct any discrepancies.
Turn off the server, remove the cover, and make sure that all cables inside
the case are attached securely. Also, make sure that the colored cable edges
are aligned correctly and that the connectors did not miss any pins.
Disconnect and reconnect the cables. Close the case (see "Closing the
case" on page 27), reconnect the modem and power cords, then turn on
the server.
Turn off the server, remove the cover and, if you have the proper test
equipment, make sure that the new battery has power. (Although
unlikely, your new battery may be defective.) Close the case (see "Closing
the case" on page 27), reconnect the power and modem cords, then turn
on the server.
62
Replacing and Adding System Components