6Kp6-Rjmsc Multi-Mode Fx-Sc "Snap-In" Fiber Connector - GarrettCom Magnum 6K8 Hardware Installation And User's Manual

Magnum 6K8-Series Industrial Field Switch
module with two 10Mb + two 100Mb multi-mode fiber module and in combine 4 ST-
Fiber ports. All four-fiber ports are ST connectors and configured as 10Mb half duplex
by default for 10Mb fiber and 100Mb Full duplex for the 100Mb fiber. The 10Mb ST-
fiber ports allow the user to connect their legacy 10Mb network to the Magnum 6K8-
Series switch. They also provide a convenient way for the half duplex hub to connect to
the switch through 10Mb fiber ports. Whereas the 100Mb ST fiber module, allow to
connect the 100Mb demand of Switch devices. It supports distances according to the
10Base-FL standard i.e., 2Km distance for multi-mode fiber. (Single-mode for 10Km
distance may be available as a special order).
Each port has an Activity (ACT) LED indicating packets being received, a
Link (LK) LED indicating proper connectivity with the remote device when lit, and
FDX/HDX LED indicating full-duplex mode when lit (or half-duplex if off).
5.2.2. 6KP6-RJMSC 4@10/100Mbps RJ-45 and 2@100Mb multi-mode FX-
SC "snap-in" Fiber connector
The Magnum 6KP6-
RJMSC is also a Combo 6 Port
module equipped with 4 10/100Mb
RJ-45 ports along with 2 multi-
mode 100Mbps fiber optic
transceivers all in one module. This
is similar to the 6K6-RJMST. It has
the same LEDs indicating port
activity (ACT), Link (LK), and
FDX / HDX and 10/100 operation, and the same faceplate lettering.
While the functionality of these two modules is essentially the same, the 6KP6-
RJMSC is equipped with an SC-type "snap-in" connector instead of an ST-type.
www GarrettCom com . .
Installation and User Guide (04/07)
6KP6-RJMSC,
4 Port@ 10/100Mbps and 2 @100 Mb SC Fiber Port
2
1 3
10/100
F/H
ACT
4
F/H
2 TX LK RX
1
LINK
3
ACTIVITY
52
1
5 7
LK
ACT
ACT
F/H
3
TX LK RX
6
2
10/100
4
FULL/HALF