GarrettCom Magnum 6K8 Hardware Installation And User's Manual page 37

Magnum 6K8-Series Industrial Field Switch
under indented side of the plate. Place two of the screws, came along the kit (#10-32 x ¼
Phillip Flat head screws with undercut) onto the indented side and screw tight the
assembly as shown in Fig 2a.
Note: Make sure the screws must have the 5lbs/in torque minimum.
a. The Din-Rail clip must be on top, while positioning the clip as shown in Fig.
2b with arrow mark.
Fig. 2a: 10-32 Screws on indented side
5. Remount the Din-Rail assembled plate onto the Magnum 6K8, using
the 4-40 screws.
Note: Torque 5lb/in max. on the 4-40 screws while tightening the screws.
The final Din-Rail assembly mounted on the Magnum 6K8 is shown below
on Fig. 3
www GarrettCom com . .
Installation and User Guide (04/07)
Fig. 2b: Din-Rail assembly w/plate
applied to mount the Din-Rail assembly
underneath.
32