Removing 6Kpm Cards - GarrettCom Magnum 6K8 Hardware Installation And User's Manual

Magnum 6K8-Series Industrial Field Switch
3.6.3

Removing 6KPM Cards

To properly remove a 6KPM card from the 6K8-Series Industrial Field Switch,
follow the 3 steps below.
Step 1. Remove chassis cover
Caution: Be sure the power cord is unplugged.
Step 2. Remove retaining screws placed on top of the 6KPMV and Face Plate
Each 6KPMV module is secured with nine retaining screws #440x3/8. These screws are
used to secure a 6KPM card in position (see Figure 3.6.3a). Remove the 9 screws to take
off the daughter module and thereafter three standoffs underneath holding the
Granddaughter board with the chassis.
using both hands, gripping the
board near the latch-up
connectors as shown in Fig.
3.6.3b
Figure 3.6.3b:
Removing a 6KPM Card
www GarrettCom com . .
Installation and User Guide (04/07)
See procedures in Section 3.6.1 above.
retaining screws shown by
arrows
Step 3.
Card
the daughter board from the latching connectors,
41
Figure 3.6.3a: 8
Remove 6KPM
Carefully and gently pull out