Installing Fpm Cards In The Magnum 4K8 Switches - GarrettCom 4K-Series Installation And User Manual

Magnum 4K8 Switches
Step 2. Remove bottom-front Retaining Screws in any PM or Face Plates
On the bottom-front of the unit, there is one retaining screw for FPM
card slot. These screws are used to secure a FPM face plate in position. These
screws are also used to secure the individual FPM cards, which can be subjected to
significant forces from the attached cables. (See Figure 3.4.1c)
MAGNUM 4K-Series
Ethernet 10/100 Switch
Figure 3.4.1c: Front View - FPM Retaining Screws hold Face Plates
PM card installation is covered in Section 3.4.2. FPM card removal is covered in
Sect.3.4.3.
3.4.2

Installing FPM Cards in the Magnum 4K8 Switches

Up to sixteen front-mounted FPM card may be installed in one Magnum 4K8
Switch unit. Follow these steps to install a FPM.
Step 1. Remove front-top chassis
above.
Step 2. The figure here illustrates
the basic layout of an
individual FPM card. Each
FPM card fits into the
selected FPM connector
socket slot. Align the
connector pins on the
bottom of the FPM card with the connector socket inside the unit. The pins are
slightly angled to facilitate the installation. (Do NOT straighten the pins
before insertion !!)
www GarrettCom com .
Installation and User Guide
1 2 3
POWER SPEED
ERROR
L/A
UPLINK
F/H
= X
cover. See procedure in
Bottom FPM Retaining
.
4 5 6 7 8 A L
F H
BOTTOM-Front FPM
Retaining Screws
TOP
LED
Printed Circuit card
Screw Hole
20
(10/04)
Section 3.4.1
Ten(10) Pin
FPM Connector
(inserts into main board)