Removing 6Kpm Cards - GarrettCom Magnum 6K16-Series Installation And User Manual

Magnum 6K16-Series Managed Fiber Switch Installation and User Guide (04/06)
installed inside of the top cover.
Step 8. Once all 6KPM cards have been installed (including faceplates for empty
slots), the chassis cover should be replaced. Make sure the chassis cover is
aligned properly before securing the enclosure.
3.6.3

Removing 6KPM Cards

To properly remove a 6KPM card from the 6K16-Series Managed Fiber
Switch, follow the 3 steps below.
Step 1. Remove chassis cover
Caution: Be sure the power cord is unplugged.
Step 2. Remove retaining screws placed on top for the 6KPM and Face Plate
On the top of the daughter module there are six
retaining screws for each 6KPM card. These
screws are used to secure a 6KPM card in
position (see Figure 3.6.3a). Remove the three
standoffs holding the Granddaughter board with
the chassis. The screen faceplate screws out from
the inside front of the chassis cover by loosening
the 4 screws and bracket while holding it down
firmly.
Figure 3.6.3a: Top View - 6 retaining s crews shown by arrows
Step 3. Remove 6KPM Card
Carefully and gently pull
out the daughter board from the latching
connectors, using both hands, gripping
the board near the latch-up connectors as
shown in Fig. 3.6.3b . If the now empty
slot is to remain unused, be sure to install
a 6KPM-BLNK face plate cover.
Figure 3.6.3b: Removing a 6KPM
Card
If another 6KPM card is replacing the one that has been removed, follow the steps as
described for installing a 6KPM card discussed in Section 3.7.1.
www GarrettCom com . .
See procedures in Section 3.6.1 above.
38