Removing Qpm Cards - GarrettCom Quad Installation And User Manual

Magnum Quad-Series Fiber Switches
Step 8. Once all QPM cards have been installed (including face plates for empty slots),
the chassis cover should be replaced.
3.9.3

Removing QPM Cards

To properly remove a QPM card from the Fiber Switch, follow the 3 steps
below.
Step 1. Remove chassis cover
Step 2. Remove bottom-front retaining screws for the QPM and Face Plate
On the bottom-front of the unit there are two retaining screws for each QPM
card and face plate slot. These screws are used to secure a QPM card in
position (see Figure 3.9.3a). Remove the front screws first and then screw
mounted on the rear-top of the QPM to be removed.
Magnum QS5116
Fiber Switch
GARRETT
Two Bottom retaining Screws for each QPM card
Figure 3.9.3a: Front View - Face Plate & QPM Retaining Screws
Step 3. Remove QPM Card
Gently pull the QPM card up and out of the connector socket (see Fig.3.9.3b).
If the slot from which the QPM card has been removed is to remain unused, be
sure to install a QPM face plate cover in it. If another QPM card is replacing
the one that has been removed, follow the steps as described for installing a
QPM card discussed in Section 3.9.1.
www GarrettCom com .
Caution: Be sure the power cord is unplugged.
QPM CARDS
Magnum QS5116
Fiber Switch
1
GARRETT
Figure 3.9.3b: Removing a QPM Card
.
Installation and User Guide (06/09)
See procedure in Section 3.9.1 above.
QPM CARDS
Magnum QS5116
Fiber Switch
1
GARRETT
J1 J2 J3
Printed Circuit card
J4
TOP
29
Two retaining screws on the rear top of
module
J1 J2 J3
Printed Circuit card
J4
TOP