Installing 6Kpm Cards In The Magnum 6K25E - GarrettCom Magnum 6K25e Installation And User Manual

Magnum 6K25e Gigabit Fiber Switch
3.5.2

Installing 6KPM Cards in the Magnum 6K25e

Up to four front-mounted 6KPM cards may be installed in one Magnum 6K25e
Managed Fiber Switch unit. Follow these steps to install a 6KPM.
Step 1. Remove top chassis cover. See procedure in Section 3.5.1 above.
Step 2. Placed Granddaughter board (as shown in fig. 3.5.2a and 3.5.2b) on the chassis
built in stand off (female) provided at the front of the 6K25e Main Board and
screw down tightly with the three 5/16 stand-off (male) on the top of the
Granddaughter board The 5/16 stand off has been used to place the daughter
board on the top of the granddaughter board and latch it securely.
Fig 3.5.2a Granddaughter Board
shown separately
Step 3. The figure here illustrates the basic layout of an individual PM card. Each
6KPM card fits into the space provided on the main board.
www GarrettCom com . .
Installation and User Guide (10/07)
Fig 3.5.2b Granddaughter Board placed in slot
A and secured with three 7/16 stand-off's
32