LeCroy WAVEJET 300A SERIES Manual page 57

DISPLAY
DESCRIPTION
COMMAND SYNTAX
QUERY SYNTAX
RESPONSE FORMAT
REMARKS
Status
DESCRIPTION
COMMAND SYNTAX
QUERY SYNTAX
RESPONSE FORMAT
Data transfer
DESCRIPTION
COMMAND SYNTAX
QUERY SYNTAX
RESPONSE FORMAT
REMARKS
917976 Rev A
WaveJet 300A Remote Control Manual
VECT
Command/Query
The VECT command enable or disable the interpolation
between data points. The VECT? query returns the state
of the interpolation.
VECT <state>
<state> := {ON, OFF}
ON := Displays waveform data in dots.
OFF := Displays waveform data in interpolated line.
VECT?
<state>
VECT ON is ignored when XYDS is XY or XYTRG.
*WAI
Command
The *WAI (WAIt to continue) command rejects permission
to execute the next command until the oscilloscope
completes execution of all of its current commands. If
the sweep method of the instrument is set to "SINGLE",
the *WAI command is used to synchronize the application
program with the completion of waveform data
acquisition.
*WAI
WAVESRC
Command/Query
The WAVESRC command selects the trace to which the
waveform data is transferred.
When transferring the waveform data (DTWAVE? query),
it is necessary to set the trace using this command,
to which the waveform data is transferred.
The WAVESRC? query returns the selected channel.
WAVESRC <dir>
<dir>:={CH1, CH2, CH3, CH4, MATH} (WJ354/334/324/314)
:={CH1, CH2, MATH} (WJ352/332/322/312)
WAVESRC?
<dir>
The trace to which the waveform data is transferred is
identified in <dir>.
57