LeCroy WAVEJET 300A SERIES Manual page 26

WaveJet 300A Series
Data transfer
DESCRIPTION
COMMAND SYNTAX
QUERY SYNTAX
RESPONSE FORMAT
REMARKS
Data transfer
DESCRIPTION
COMMAND SYNTAX
QUERY SYNTAX
RESPONSE FORMAT
REMARKS
26
DTPOINTS
Command/Query
The DTPOINTS command defines the amount of waveform
data to be transferred. The
DTPOINTS? query returns the defined amount of waveform
data to be transferred.
DTPOINTS <points>
<points>:=1 to (waveform data length - DTSTART)
Any values exceeding this range are rounded to the
maximum or minimum permissible value, whichever is
nearest.
DTPOINTS?
<points>
The defined amount of waveform data to be transferred
is identified in <points>. The
format is <NR1 Numeric Response Data>.
(Transfer start address) + (Amount of data to be
transferred) > (Total amount of waveform data)
When DTPOINTS command causes the above case, the
transfer start address is rounded to a permissible
value.
DTSTART
Command/Query
The DTSTART command defines the transfer start address
for waveform data transfer.
The DTSTART? query returns the defined transfer start
address.
DTSTART <start>
<start>:=0 to (waveform data length - 1)
Any values exceeding this range are rounded to the
maximum or minimum permissible value, whichever is
nearest.
DTSTART?
<start>
The defined start address for waveform data transfer
is identified in <start>. The format is <NR1 Numeric
Response Data>.
(Transfer start address) + (Amount of data to be
transferred) > (Total amount of waveform data)
When DTSTART command causes the above case, the amount
of data to be transferred is rounded to a permissible
value.
917976 Rev A