LeCroy WAVEJET 300A SERIES Manual page 39

Save/Recall
DESCRIPTION
COMMAND SYNTAX
QUERY SYNTAX
RESPONSE FORMAT
REMARKS
Horizontal
DESCRIPTION
COMMAND SYNTAX
QUERY SYNTAX
RESPONSE FORMAT
REMARKS
Save/Recall
DESCRIPTION
COMMAND SYNTAX
QUERY SYNTAX
RESPONSE FORMAT
Acquisition
DESCRIPTION
COMMAND SYNTAX
QUERY SYNTAX
RESPONSE FORMAT
917976 Rev A
WaveJet 300A Remote Control Manual
*RCL
Command
The *RCL command recalls the oscilloscope front panel
setup data from one of five internal memory areas.
*RCL <panel_setup>
<panel_setup>:0, 1 to 5
0 := to recall default setup.
1 to 5 := to recall setup from one of five internal memory
areas.
ROLL
Command/Query
The ROLL command enables or disables roll operations.
The ROLL? query returns the current roll operation
status.
ROLL <state>
<state>:={ON, OFF}
ROLL?
<state>
When roll operation is enabled while acquisition is
average, the acquisition mode is set to normal.
Roll operation is turned off when XYDS is XY or XYTRG.
*RST
Command
The *RST command enables device reset. The *RST command
recalls the default setups.
*RST
RUN
Command
RUN sets the trigger mode to "AUTO" and starts waveform
acquisitions. If the trigger mode is already "AUTO",
this command is ignored. RUN acts same as "TRMD AUTO".
RUN
39