LeCroy WAVEJET 300A SERIES Manual page 49

(Delay value resolution) = (Sweep time) / 50
• When the specified resolution is not equal to the above value, it is rounded
to the permissible value of which the absolute value is smaller.
Acquisition
DESCRIPTION
COMMAND SYNTAX
QUERY SYNTAX
RESPONSE FORMAT
REMARKS
Acquisition
DESCRIPTION
COMMAND SYNTAX
QUERY SYNTAX
RESPONSE FORMAT
REMARKS
917976 Rev A
WaveJet 300A Remote Control Manual
*TRG
Command
The *TRG command sets the trigger mode to "SINGLE" to
start single waveform acquisition.
*TRG
*TRG reports device-specific error (DDE) and is not
performed when XYDS is XY.
TRMD
Command/Query
The TRMD command selects the trigger mode. The TRMD?
query returns the currently selected trigger mode.
TRMD <mode>
<mode> := {AUTO, NORMAL, SINGLE, STOP}
AUTO := Set trigger mode to AUTO when scope is not in
roll mode operation. If roll mode is on and scope is
in roll mode operation range, AUTO initiates ENDLESS
roll acquisition.
NORMAL := Set trigger mode to NORMAL when scope is not
in roll mode operation. If roll mode is on and scope
is in roll mode operation range, NORMAL initiates
repeated TRIG'D roll acquisitions.
SINGLE := Set trigger mode to NORMAL when scope is not
in roll mode operation. If roll mode is on and scope
is in roll mode operation range, SINGLE initiates
single TRIG'D roll acquisition.
TRMD?
<mode>
Not in roll mode operation: AUTO, NORMAL, SINGLE or STOP
In roll mode operation: ENDLESS, TRIG'D, TRIG'D or STOP
TRMD SINGLE reports device-specific error (DDE) and is
not performed when XYDS is XY.
49