1
Characteristics and Specifications
Transient Withstand Capability
C A U T I O N
C A U T I O N
C A U T I O N
16
Maximum input voltage for analog inputs
CAT I 300 Vrms, 400 Vpk; transient overvoltage 1.6 kVpk
with 10073C or 10074C 10:1 probe: CAT I 500 Vpk
Do not exceed 5 Vrms in 50
50
mode, and the 50
detected. However, the input could still be damaged, depending on the
time constant of the signal. The 50
functions when the oscilloscope is powered on.
Maximum input voltage for logic channels:
±40 V peak CAT I; transient overvoltage 800 Vpk
mode. Input protection is enabled in
load will disconnect if greater than 5 Vrms is
input protection mode only
7000 Series Oscilloscopes Service Guide