Transient Withstand Capability - Agilent Technologies 2000 X-Series Service Manual

1 Characteristics and Specifications

Transient Withstand Capability

C A U T I O N
C A U T I O N
C A U T I O N
18
Maximum input voltage for analog inputs
CAT I 300 Vrms, 400 Vpk; transient overvoltage 1.6 kVpk
with 10073C 10:1 probe: CAT I 500 Vpk, CAT II 400 Vpk
with N2862A/B or N2863A/B 10:1 probe: 300 Vrms
Do not exceed 5 Vrms in 50
Input protection is enabled in 50
disconnect if greater than 5 Vrms is detected. However, the input could
still be damaged, depending on the time constant of the signal. The 50
input protection mode only functions when the oscilloscope is
powered on.
Maximum input voltage for logic channels:
±40 V peak CAT I; transient overvoltage 800 Vpk
mode (3000 X-Series oscilloscopes only).
mode, and the 50
2000/3000 X-Series Oscilloscopes Service Guide
load will