To Remove The Rear Deck Assembly; Figure 19. Removing The Rear Deck Assembly - Agilent Technologies InfiniiVision 7000 Series Service Manual

5 Replacing Assemblies

To remove the Rear Deck Assembly

WA R N I N G
88
Removing the rear deck allows access to the front deck,
acquisition board, and inverter board.
1 Using a T20 TORX, locate and remove all screws securing
rear deck to front deck.
2 Remove BNC securing nuts and washers.
Removing the rear deck assembly
Figure 19
3 Carefully separate rear deck from front deck. Take care
not damage extender switch.
Sheet metal parts may have sharp edges. Handle with care to avoid injury.
7000 Series Oscilloscopes Service Guide