Agilent Technologies InfiniiVision 7000 Series Service Manual page 71

WA R N I N G
7000 Series Oscilloscopes Service Guide
3 Connect the power cord to the rear of the oscilloscope,
then to a suitable ac voltage source.
The oscilloscope power supply automatically adjusts for
input line voltages in the range of 100 to 240 VAC. Ensure
that you have the correct line cord (see
power cord provided is matched to the country of origin.
AVOID INJURY.
Always operate the oscilloscope with an approved three conductor power cable.
Do not negate the protective action of the three conductor power cable.
• Press the power switch.
• When the oscilloscope is turned on, the front panel
LEDs will briefly light up in groups from bottom to
top.
• Next the Agilent logo appear on the display.
• Next a message will appear with tips on getting started
using the oscilloscope. At this time you can press any
key to remove the message and view the display. Or
you can wait and the message will automatically
disappear.
• It will take a total of about 10- 15 seconds for the
oscilloscope to go through its basic self test and
power- up routine.
4 Proceed to
"To verify basic oscilloscope operation"
page 72.
Troubleshooting
page 105). The
on
71
4