Figure 23 Unlocking Alignment Pin; Figure 24 Removal Of Inverter Board - Agilent Technologies InfiniiVision 7000 Series Service Manual

5 Replacing Assemblies
92
4 Carefully unlock the two alignment pins. Carefully lift
acquisition board off front deck.
Unlocking alignment pin
Figure 23
5 Using a TORX T10 driver locate and remove the two
screws securing the Dual Inverter board to the front deck.
6 Disconnect all cables, lift board off front deck.
Removal of inverter board
Figure 24
7000 Series Oscilloscopes Service Guide