35.3.1 Backup Configuration
Follow the instructions as shown in the next screen.
Figure 204 Menu 24.5: Backup Configuration
To transfer the configuration file to your computer, follow the procedure
below:
1. Launch the FTP client on your computer.
2. Type "open" and the IP address of your system. Then type "root" and
SMT password as requested.
3. Locate the 'rom-0' file.
4. Type 'get rom-0' to back up the current system configuration to your
computer.
For details on FTP commands, please consult the documentation of your FTP
client program.
remain
in this menu to back up using TFTP), please see your user manual.
35.3.2 Using the FTP Command from the Command Line
Launch the FTP client on your computer.
1
Enter "open", followed by a space and the IP address of your P-793H v2.
2
Press [ENTER] when prompted for a username.
3
Enter your password as requested (the default is "1234").
4
Enter "bin" to set transfer mode to binary.
5
Use "get" to transfer files from the P-793H v2 to the computer, for example, "get
6
rom-0 config.rom" transfers the configuration file on the P-793H v2 to your
computer and renames it "config.rom". See earlier in this chapter for more
information on filename conventions.
Enter "quit" to exit the ftp prompt.
7
P-793H v2 User's Guide
Chapter 35 Firmware and Configuration File Maintenance
Menu 24.5 - Backup Configuration
For details on backup using TFTP (note that you must
389