Lan Ip Alias; Figure 147 Menu 3.2.1: Ip Alias Setup; Table 115 Menu 3.2.1: Ip Alias Setup - ZyXEL Communications P-793H User Manual

Chapter 26 LAN Setup

26.4 LAN IP Alias

Use menu 3.2 to configure the first network, and you use menu 3.2.1 to configure
the other two networks. Move the cursor to the Edit IP Alias field, press [SPACE
BAR] to choose Yes and press [ENTER] to configure the second and third network.

Figure 147 Menu 3.2.1: IP Alias Setup

Use the instructions in the following table to configure IP alias parameters.

Table 115 Menu 3.2.1: IP Alias Setup

FIELD
IP Alias 1, 2
IP Address
IP Subnet
Mask
RIP Direction
Version
Incoming
protocol filters
Outgoing
protocol filters
When you have completed this menu, press [ENTER] at the prompt [Press ENTER to
Confirm...] to save your configuration, or press [ESC] at any time to cancel.
320
Menu 3.2.1 - IP Alias Setup
IP Alias 1= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
DESCRIPTION
Choose Yes to configure the LAN network for the P-793H v2.
Enter the IP address of your P-793H v2 in dotted decimal notation.
Your P-793H v2 will automatically calculate the subnet mask based on
the IP address that you assign. Unless you are implementing subnetting,
use the subnet mask computed by the P-793H v2.
Press [SPACE BAR] and then [ENTER] to select the RIP direction. Options
are
Both, In Only, Out Only or None.
Press [SPACE BAR] and then [ENTER] to select the RIP version. Options
are
RIP-1, RIP-2B or RIP-2M.
Enter the filter set(s) you wish to apply to the incoming traffic between
this node and the P-793H v2.
Enter the filter set(s) you wish to apply to the outgoing traffic between
this node and the P-793H v2.
P-793H v2 User's Guide